Wall Water Shut-Off Valve Replacement
Water shut-off valves are crucial for controlling water flow in the pipes inside the walls. They are primarily used to stop water flow when replacing toilets and faucets, providing a convenient alternative to shutting off the whole house’s water supply.
Common Problems
- Leaks
- Over time, some sealing components inside the valve degrade and fail. Even when the valve is shut off, the damaged components inside can prevent the water flow from stopping.
- Inability to Turn
- From broken pieces to corrosion, these valves are prone to seizing in place.
Difficulty
Replacing the valve requires plumbing knowledge and tools that average homeowners don’t have.
Time Needed
Cost Breakdown
Professional
Parts: $10 – $30
Labor: $150 – $300
Total: $160 – $330
DIY
Parts: $10 – $30
Tools: $20 – $50
Total For Homeowners without tools: $30 – $80
Difference
DIY Homeowner with tools saves: $150 – $300
DIY Homeowner without tools saves: $130 – $250
Tools and Supplies
Amazon Affiliate Links Listed Below
Explanation
First, the water supply is turned off at your house’s primary water supply, which drains the pipes and allows work on the valve. After cleaning the pipe, the valve is installed by tightening it. Then, the valve is secured and tested for leaks by slowly turning the water back on. Finally, the valve is checked to ensure that it operates correctly.
How It’s Done
- For Metal Pipe
- Identify the size of your house supply pipe, usually ½ inches unthreaded. Although the material may differ, the valve will work with any material if the pipe size is correct.
- Turn off the house’s primary water supply, usually in an interior closet or utility room.
- Open a nearby faucet to relieve pressure on the pipes. If the tank is connected to a toilet, flush it to drain it.
- Loosen the compression nut on the back of the valve that connects it to the supply pipe.
- Remove the old valve.
- Clean the supply pipe to ensure a good seal for the new valve.
- Keep or replace the cosmetic pipe cover.
- Install the new valve on the supply pipe, then tighten the compression nut with pliers until it is snug.
- Turn the main water supply for your house back on.
- Test for leaks by slowly turning the water back on and checking the valve.
- For Plastic Pipe and PEX Pipe
- Removal
- Identify whether your house supply pipe is plastic PVC or PEX.
- Turn off the main water supply to the house.
- Open a nearby faucet to relieve pressure on the pipes.
- Cut the existing pipe using a pipe cutter to remove the old valve.
- Smooth the edges of the cut pipe with sandpaper or a deburring tool.
- Installation:
- Use a push-to-connect valve or crimp fitting with the appropriate tool.
- Install the new valve securely according to the pipe type.
- Turn the main water supply for your house back on.
- Test for leaks by slowly turning the water back on and checking the valve.
- Removal
