Toilet Supply Line Set Up
Water supply lines carry water from the wall valve to the toilet, ensuring that the pressure stays constant without leaks.
Common Problems
- Leaks
- Caused by corrosion, kinks, and wear over time
Difficulty
Replacing water supply lines is straightforward. With some basic repair knowledge, most people should be able to accomplish it with little strain.
Time Needed
Cost Breakdown
Professional
Parts: $5 – $20
Labor: $100 – $250
Total: $105 – $270
DIY
Parts: $5 – $20
Tools: $20 – $50
Total For Homeowners without tools: $30 – $80
Difference
DIY Homeowner with tools saves: $150 – $300
DIY Homeowner without tools saves: $130 – $250
Tools and Supplies
Amazon Affiliate Links Listed Below
Explanation
To replace the supply pipe connecting the wall valve and the toilet, remove the old pipe and install a new pipe with the same length and fitting, ensuring a clean fit that will not leak.
How It’s Done
- Shut off the wall valve located behind the toilet using the Wall Shut-off Valve.
- Flush the toilet to drain the tank
- If replacing an old supply line, remove it by loosening the connections (one underneath the toilet tank and one on the wall water valve) using pliers. The toilet connection will be a large plastic nut, and the valve connection will be a smaller silver nut.
- Wrap Teflon tape around the threads of the wall valve and the toilet tank to ensure a tight seal and prevent leaks.
- Attach the new flexible supply line to the valve and tighten it securely with the pliers.
- Attach the other end of the supply line to the toilet’s inlet valve and tighten it snugly.
- Turn on the wall valve and check the connections for any leaks using the Wall Shut-off Valve.
